Once cut, strip the cable and solder it to the button, making sure to have a strong connection. I cut mine to be about three metres long, since I'm not that far from my Xbox. The cable connecting to the lag switch must be cut to a length that allows you to be in whatever location you will be playing and still attached, plus some extra slack. Once the battery compartment is cut and drilled, it's time to add the trigger. but it's not necessary.)Ī SPDT (single-pole, double-throw) 6 volt relay Two watch-battery holders (CR-2032, CR-2025 or CR-2016 recommended.)Ī normally-open push button (I used a button that had both N.O. Shielded wire (we'll be using the shield as another wire, feel free to substitute a different type of wire.) Veroboard Spare Xbox 360 controller battery shell (it won't ever hold batteries again, make sure you aren't using it.) Tools:Įthernet cable (the length is up to you, I used a short one as the distance between my router and Xbox is tiny.)Įnclosure/project box (again, size is up to you, but smaller is better in this case.) This Instructable is a fairly easy one, requiring only a few common tools and some cheap parts from your local Radio Shack or equivalent.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |